LocoBlade SVA Test

Today was the day i had been dreading for quite some time, for today was my appointment for the Locoblade to have its Single Vehicle Approval test so that i can drive it on the road...

It failed, however it wasn't as bad as i thought it could of been, passed somethings i thought would fail and some things didn't that i thought would.

My list of stuff that failed/todo:

1. Rear harness belts points need trim round them.
2. Steering wheel bracket needs foam round each end where its welded to the top rail.
3. Refix the mirrors to provide proper field of vision.
4. 4. Supply fuel hose cert and fixing pictures.
5. 5. Near side rear brake/side light need switching over so the correct bulb is switched on (swap wires!).
6. Rear fog light bottom edge to be rounded to 2.5 radius.
7. Brake fluid warning light needs to be illuminated (Get clear sticker over the top of dash).
8. Cannot see roll pins in balance bar. Get longer pins for balance bar or lock nut and pin ends.
9. Excessive nose 103db, limit is 101db, need to get exhaust wadding.
10. Excessive emissions over 3.5%CO.
11. 11. Setup Digidash so that MPH is displayed at all times, needs MPH sticker.
12. Remake brake fluid reservoir bracket.